Stella Symphony

- Python で開発できる Zynq 7020 評価ボード、PYNQ オープンソースフレームワークのハードウェアプラットフォーム
- プロセッサ： Dual-Core ARM Cortex-A9、FPGA： ZYNQ XC7Z020-1CLG400C
- メモリ： 512MB DDR3、16MB Quad-SPI フラッシュ、MicroSD スロット
- USB-JTAG、USB-UART、USG OTG PHY、Gigabit Ethernet PHY
- HDMI In/Out、Arduino ヘッダー、Pmod ポート x2、ユーザLED x6、プッシュボタン x4、スイッチ x2

Features:
- ZYNQ XC7Z020-1CLG400C:
　- 650MHz dual-core Cortex-A9 processor
　- DDR3 memory controller with 8 DMA channels and 4 high performance AXI3 slave ports
　- High-bandwidth peripheral controllers: 1G Ethernet, USB 2.0, SDIO
　- Low-bandwidth peripheral controller: SPI, UART, CAN, I2C
　- Programmable from JTAG, Quad-SPI flash, and microSD card
　- Artix-7 family programmable logic
 - 13,300 logic slices, each with four 6-input LUTs and 8 flip-flops
 - 630 KB of fast block RAM
 - 4 clock management tiles, each with a phase-locked loop (PLL) and mixed-mode clock manager (MMCM)
 - 220 DSP slices
 - On-chip analog-to-digital converter (XADC)
- Memory:
　- 512MB DDR3 with 16-bit bus @ 1050Mbps
　- 16MB Quad-SPI Flash with factory programmed globally unique identifier (48-bit EUI-48/64™ compatible).
　- MicroSD slot
- Power: 
　- Powered from USB or any 7V-15V source (see recommended products)
- USB and Ethernet:
　- USB-JTAG Programming circuitry
　- USB-UART bridge
　- USB OTG PHY (supports host only)
　- Gigabit Ethernet PHY
- Audio and Video:
　- Electret microphone with pulse density modulated (PDM) output
　- 3.5mm mono audio output jack, pulse-width modulated (PWM) format
　- HDMI sink port (input)
　- HDMI source port (output)
- Switches, push-buttons, and LEDs:
　- 4 push-buttons
　- 2 slide switches
　- 4 LEDs
　- 2 RGB LEDs
- Expansion Connectors:
　- Two standard Pmod ports
   - 16 Total FPGA I/O
　- Arduino/chipKIT Shield connector
   - 49 Total FPGA I/O
   - 6 Single-ended 0-3.3V Analog inputs to XADC
   - 4 Differential 0-1.0V Analog inputs to XADC

PYNQ-Z1 リファレンスマニュアル
 

PYNQ ホームページ